Making A Call; Call Setup And Transmission; Transmit Timer - Tait t2040 series ii Operator's Manual

Table of Contents

Advertisement

Making a Call

There are four different ways of making a call using your T2040II:
Enter the full number of the required party using the alphanumeric keypad and then
1
press either the Hash key (
Enter short dial preset numbers using the alphanumeric keypad and then press the
2
Hash key (
Use the Despatcher key (
3
preprogrammed numbers and used for one touch calling. The Despatcher key (
is usually programmed to be your base despatcher.
Press the Alphanumeric key (
4
Down keys (
party is shown in the display. Press the Hash key (
(See
"Advanced User Operations", on page 14
dialling.)
Note: The
indicator illuminates each time you operate the PTT key.
TX

Call Setup and Transmission

You may hear call set-up tones,
called unit rings, the tone changes to
call but cannot connect it immediately, you hear a similar tone to the call setup tone, but lower-
pitched,
pip.. pip.. pip.. pip
When the called party answers, the
illuminates. Proceed with the call as follows:
Lift the microphone off its hook and hold it about 5 cm from your mouth.
1
Squeeze the PTT key and speak clearly into the microphone. Release the PTT key
2
when you have finished talking.
End the call by placing your microphone back onto its hook or by pressing the Clear key
3
(
).
The network may also end the call if neither you nor the other party transmits for a pre-
determined time.

Transmit Timer

Your T2040II is fitted with a preprogrammed timer to limit the maximum length of transmis-
sions. Your radio sounds five tones, beginning eight seconds before the call is automatically
'cleared down'. You must release the PTT key before proceeding.
10
) or PTT key to send the call.
) or PTT key to send the call.
) or Function key (
/
) to scroll through a list of labels, until the label of the required
pip.. pip.. pip
buzz, buzz... buzz, buzz
, and the
indicator flashes.
WAIT
indicator turns off, the tones stop and the
WAIT
). These keys can be assigned
) to enter alphanumeric mode. Use the Up and
) or PTT key to send the call.
for more information on alphanumeric
.., and the
indicator illuminates. When the
WAIT
.... If the network accepts your
)
indicator
GO
02/99 IPN: 409-20400-02

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents