Philips HB185/01 User Manual page 9

Never use scouring pads and abrasive liquids such as scouring agents, petrol or acetone to clean
the appliance.
1 Clean the protective goggles with a moist cloth.
Replacement
The light emitted by the tanning lamps will become less bright in time (i.e. after a few years in case
of normal use). When this happens, you will notice a decrease in the tanning capacity of the
appliance. You can solve this problem by setting a slightly longer tanning time or by having the
tanning lamps replaced.
Always have the tanning lamps and starters replaced by a service centre authorised by Philips.
Only they have the knowledge and skills required for this job and the original spare parts for
your face tanner.
Additional or replacement goggles, type HB071, can be ordered under service number 4822 690
80123.
Environment
The lamps of face tanners contain substances that may pollute the environment. When you
,
discard the lamps, do not throw them away with the normal household waste, but dispose of
them at an official collection point.
Do not throw the appliance away with the normal household waste at the end of its life, but
,
hand it in at an official collection point for recycling. By doing this you will help to preserve
the environment (Fig. 4).
guarantee & service
If you need service or information or if you have a problem, please visit the Philips website at
www.philips.com or contact the Philips Customer Care Centre in your country (you will find its
phone number in the worldwide guarantee leaflet). If there is no Customer Care Centre in your
country, turn to your local Philips dealer or contact the Service Department of Philips Domestic
Appliances and Personal Care BV.
guarantee restrictions
The tanning lamps are not covered by the terms of the international guarantee.
troubleshooting
If problems should arise with this appliance and you are unable to solve them by means of the
information below, please contact the nearest Philips service centre or the Philips Customer Care
Centre in your country.
Problem
The appliance does
not start.
Poor tanning results.
Solution
Make sure the plug has been properly inserted into the wall socket.
There may be a power failure. Check if the power supply works by
connecting another appliance.
You are not following the tanning schedule suitable for your skin type.
Check the table in section 'Tanning sessions: how often and how long?'.
The distance between the lamps and your face is larger than prescribed.
EngliSH
9