Paradyne Hotwire 8775 Installation Instructions Manual page 9

8775-A2-GZ40-10
— On a Hotwire 8800 Series DSLAM chassis:
SLOTS 13-18
SLOTS 7-12
SLOTS 1-6
Anchor Mount
SLOTS 1-6
2. Replace the longer Telco cable captive screw with a shorter connector
captive screw, which is provided with the Hotwire DSLAM chassis.
3. Insert a cable tie (provided with Hotwire DSLAM chassis) through the tie
mount to hold the Telco 50-pin connector in place. If more than one Telco
cable is being connected, span the two or three connectors.
4. Make sure the other end is connected to the appropriate MDF or demarcation
point.
Refer to Cables and Pin Assignments in the User's Guide for pinouts.
NOTE:
If you are connecting the Telco 25-pair, 50-pin cable to an MDF, a converter
may be necessary for terminating the other end of the cable on a punchdown
block before cross-connecting to an MDF.
March 1999
LINES
Shorter
Telco
Captive Screw
Telco 50-Pin
Connector
LINES
97-15325
9