Operational Instructions - Stamina 40-0041A Owner's Manual

OPERATIONAL INSTRUCTIONS

USING THE FITNESS MONITOR
POWER ON:
Pedal movement or press the button.
POWER OFF:
After four minutes of inactivity, the monitor
automatically shuts off. Function values are not
saved.
FUNCTION BUTTON:
Press and release to select the function of the lower readout.
Press and hold for three seconds to reset all functions to zero.
FUNCTIONS:
COUNT : Upper readout displays the total number of strides you have taken from zero to 9999 strides.
SCAN: Automatically scans each function of REPS/MIN, TIME, and CALORIE in sequence with
change every six seconds. Press and release the button until the arrow appears on the
display and points to the SCAN.
REPS/MIN: Displays the rate of strides per minute.
TIME: Displays the stepping time from one second up to 99:59 minutes. After six seconds of inactivity,
the meter will automatically stop timing the workout. Restart the workout time by moving the
pedals.
CALORIE: Displays the calorie burned from zero to 9999 Kcal.
The calorie readout is an estimate for an average user. It should be used only as a comparison
between workouts on this unit.
BATTERY
The monitor operates with a 1.5v LR44 button cell battery. Replace the battery when you see inconsistencies
in the display.
HOW TO INSTALL AND REPLACE BATTERY:
1. Remove the MONITOR(7) from the Stamina® Mini Stepper. Unplug
the SENSOR WIRE(24). Place the MONITOR(7) up-side down as
shown in the illustration.
2. Refer to the illustration. Slide out the old battery.
3. Install a new button cell battery. Assembly the MONITOR(7) back to
the Stamina® Mini Stepper.
NOTE: 1. Ultimate disposal of battery should be handled according
to all state and federal laws and regulations.
2. Do not dispose of batteries in fire.
9
REPS
MIN
SCAN
MODE
LR44
Battery
COUNT
TIME
CALORIE