Assembly Instructions - Stamina 40-0041A Owner's Manual

ASSEMBLY INSTRUCTIONS

Place all parts from the box in a cleared area and position them on the floor in front of you. Remove
all packing materials from your area and place them back into the box. Do not dispose of the packing
materials until assembly is completed. Read each step carefully before beginning. If you are missing
a part, please go to staminaproducts.com under the Customer Care section and order the part
needed, e-mail us at customer.care@staminaproducts.com, or call us toll free at 1-800-375-7520
(in the U.S.). Our Customer Care Staff is available to assist you from 7:30 A.M. to 5:00 P.M. (Central
Time) Monday through Thursday and 8:00 A.M. to 3:00 P.M. (Central Time) on Friday.
Some product parts are fit tested at the factory to ensure proper fit and alignment. Marks in
the paint may be noticeable, but are not an indication of damage.
STEP 1
Refer to detail view A. The PULLEY BRACKET(3) is tied to the MAIN FRAME(1) with a nylon strap for
packing. Use scissors to carefully cut and remove the nylon strap.
STEP 2
Refer to the illustration below. Lift the RIGHT PEDAL ARM(10) up as shown. Place the CABLE(4) in the
groove on the PULLEY(5) properly, then press the RIGHT PEDAL ARM(10) down.
7
A.
Nylon Strap