Use Of The Capacity Chart; Capacity Indicator Locations - JLG G10-55A Operation & Safety Manual

5.5

USE OF THE CAPACITY CHART

To properly use the capacity chart (see page 5-6), the operator must first determine
and/or have the following:
1. An approved attachment. See "Approved Attachments" on page 5-1.
2. The proper Capacity Chart(s).
3. Weight of the load being lifted.
4. Load placement information:
a. HEIGHT where the load is to be placed.
b. DISTANCE from the front tires of the telehandler where the load is to be
placed.
5. On the capacity chart, find the line for the height and follow it over to the
distance.
6. The number in the load zone where the two cross is the maximum capacity for
this lift. If the two cross at a division between zones, the smaller number must
be used.
The number in the load zone must be equal to or greater than the weight of the load
to be lifted. Determine the limits of the load zone on the capacity chart and keep
within these limits.

Capacity Indicator Locations

ATTACHMENT
IDENTIFICATION
PLATE
FORK
WEIGHT
STAMP
31200745
BOOM ANGLE
BOOM
INDICATOR
EXTENSION
INDICATOR
Section 5 - Attachments
DO NOT GO NEAR LEAKS
* High pressure oil easily punctures skin causing serious injury, gangrene or death.
* Lower load or relieve hydraulic pressure before loosening fittings. * Do not use finger or skin to check for leaks. * If injured, seek emergency medical help. Immediate surgery is required to remove oil.
C 10814B
OY1510
5-5