Advertisement
Available languages
Available languages
Problem
appliance general
It is not possible to close
the doors.
There is frost on the keg or
on the appliance.
Beer leaks out of the
appliance.
The appliance makes a
sound.
The pump goes on
frequently when I am not
pouring beer.
tap unit
It is difficult to place the tap
unit onto the keg.
It is difficult to press the
release buttons to remove
the tap unit.
-
you use kegs from other suppliers than the ones mentioned in this user
manual.
The kegs and tubes are not covered by this guarantee.
,
troubleshooting
If you are unable to solve the problem with the information below,
contact us online at www.philips.com or call the PerfectDraft call centre
at 078-250159 (Belgium), 01801-324000 (Germany) or 0900-2224222
(Netherlands).
Solution
Make sure you push down the blue locking levers until they are in
horizontal position before you close the doors.
Make sure the tube is placed correctly in the tap unit and the tap handle is
in upright position. See chapter 'Preparing for use', section 'Placing the tube
into the tap unit'.
Make sure the tap unit is placed correctly on the keg.
Unplug the appliance and let the keg or appliance defrost. Dry
the appliance or keg with a cloth.
Make sure that the doors are properly closed. For instructions on how to
close the doors, see the chapter 'Preparing for use', section 'Placing the keg
into the appliance'. It is normal for some frost to be present on the back
of the keg.
Make sure that the tap unit and the tube are placed correctly (see chapter
'Preparing for use', sections 'Placing the tap unit onto the keg' and 'Placing
the tube into the tap unit').
Remove the tap unit and tube and reinstall them. If the problem continues
to occur, contact the PerfectDraft call centre in your country to obtain a
new tube.
Because the appliance chills constantly, the fan works continuously.
The pump may go on while you pour beer to maintain the right pressure.
When you are not pouring beer, the pump also goes on every now and
then to keep the appliance at the right pressure.
Reinstall the tap unit and tube. If this does not help, try another keg
together with a new tube. If the problem continues to occur, contact the
PerfectDraft call centre in your country.
Make sure no old beer is left in the tap unit. Clean the entire tap unit with
hot water and, if necessary, some washing-up liquid.
First remove the keg from of the appliance. Then press the release buttons
to remove the tap unit from the keg.
EnglisH
1
Advertisement
