Philips HD3610/50 User Manual page 11

Placing the keg into the appliance
Never place the keg into the appliance if you have not assembled the tap
unit and the tube properly. See sections 'Placing the tap unit onto the
keg' and 'Placing the tube into the tap unit' in this chapter.
1 Slide the release button to the right to open the doors.
 Lift the two blue locking levers completely.
 Tilt the keg with the assembled tap unit slightly forward and put it
into the appliance.
- First put the keg on the cooling plate of the appliance.
- Then put the keg upright by sliding the tap unit between the blue
locking levers.
 Push down the blue locking levers until they are in horizontal
position.
If you are unable to put the locking levers in horizontal position, you have
not put the keg into the appliance in the right position. Take out the keg
and follow steps 1 to 3 again.
After you have installed the keg (even the first time), the pump runs
,
for a few seconds.
5 Close the doors.
EnglisH
11