Philips HD3610/50 User Manual page 20

EnglisH
0
5 Pull the cooling fan out of the appliance.
Now you see an aluminium plate with fins on it and with two screw
,
holes.
6 Undo the screws with a screwdriver.
 Remove the aluminium plate.
After you have removed the aluminium plate, you see a white plate
,
of approx.  x cm. This is the actual cooling element.
 Place the flat blade of a screwdriver behind the cooling element.
Twist the screwdriver to pry the cooling element off the back of the
aluminium plate.
 Cut the wires attached to the cooling element.
Do not connect the appliance to the mains again after you have removed
the cooling element.
Never reassemble the cooling element once you have removed it.
10 Hand in the cooling element at an official collection point for
chemical waste.
guarantee & service
If you need information or if you have a problem, contact us online at
www.philips.com or call the PerfectDraft call centre. Their phone number
is 078-250159 (Belgium), 01801-324000 (Germany) or 0900-2224222
(Netherlands).
When you take the appliance to your dealer or a Philips service centre for
determination of the cause of the problem, also bring the tube and the keg.
guarantee restrictions
Your guarantee becomes invalid if:
- you do not use the appliance according to the instructions in this user
manual.
- you use damaged kegs in this appliance.
- you do not install the kegs according to the instructions in this user
manual.