Thermal Module - HP MS218 Maintenance And Service Manual

8.
To install the fan, reverse the removal procedures.

Thermal module

1.
2.
3.
4.
5.
6.
7.
8.
Downloaded from www.Manualslib.com
Disconnect the fan cable from the system board (2), and then remove the fan from the computer.
Prepare the computer for disassembly (see
Remove the stand (see Stand on page
Remove the hard drive (see
Remove the optical drive (see
Remove the back cover (see
Remove the system board shield (see
Remove the fan (see Fan on page
Loosen the captive screws from the thermal module, as follows:
a. (1) Two screws for the chipset heat sink
b. (2) Four screws for the processor heat sink
c. (3) Two screws for the graphics card heat sink
manuals search engine
Preparing to disassemble the computer on page
11).
Hard drive on page 13).
Optical drive on page 16).
Back cover on page 18).
System board shield on page
22).
5).
19).
Thermal module 23