Fan - HP MS218 Maintenance And Service Manual

5.
6.
7.
8.
9.
To install the WLAN module, reverse the removal procedures.

Fan

1.
2.
3.
4.
5.
6.
7.
22 Chapter 3 Removal and Replacement Procedures
Downloaded from www.Manualslib.com
Remove the back cover (see
Remove the system board shield (see
Remove the antenna cables (1) from the module.
Remove the screw (2) that secures the module to the system board.
NOTE: Some modules may be secured by two screws.
Lift the module out of the slot at an angle.
NOTE: The WLAN module has a notch to prevent incorrect installation.
Prepare the computer for disassembly (see
Remove the stand (see Stand on page
Remove the hard drive (see
Remove the optical drive (see
Remove the back cover (see
Remove the system board shield (see
Remove the four screws (1) that secure the fan to the system board, and then lift the fan partially
out of the computer.
manuals search engine
Back cover on page 18).
System board shield on page
Preparing to disassemble the computer on page
11).
Hard drive on page 13).
Optical drive on page 16).
Back cover on page 18).
System board shield on page
19).
5).
19).