Vinten Vision Pozi-Loc Maintenance Manual page 108

Table of Contents

Advertisement

Contents
Introduction
1
Carrying straps are available as optional accessories for Pozi-Loc tripods. Carrying strap 3425-3P will
fit 75/100 mm ENG tripods and 150 mm EFP tripods. Carrying strap 3425-3C will fit 100 mm EFP tripods.
Consumables
2
The following consumable will be required:
Loctite 221 (Vinten Part No. Z002-026)
White Chesterton grease (Vinten Part No. Z150-105)
Installation - 150 mm EFP tripods
3
Install the carrying strap on EFP (150 mm bowl) tripods as follows:
3.1
On the underside of the tripod bowl, identify the M6 tapped hole (8).
3.2
Position the bowl strap anchor
oriented. Using Loctite 221, secure the bowl strap anchor with the 25 mm M6 screw
the strap.
3.3
On the lower moulding of the corresponding leg, drive in the 'knock-out'
If possible, remove the blank from inside the moulding to prevent subsequent rattle.
3.4
Push a blind captive nut
3.5
Using a suitable M5 screw, fully compress the blind captive nut. Remove the M5 screw.
3.6
Install a washer
the hole in the strap anchor is oriented so that the karabiner
3.7
Using the karabiners (1.1), clip the strap
Installation - 75/100 mm ENG tripods
3.8
Install the carrying strap on ENG (75 mm/100 mm bowl) tripods as follows:
3.9
On the lower moulding of the leg with the strap, drive in the 'knock-out'
possible, remove the blank from inside the moulding to prevent subsequent rattle.
3.10 Push a blind captive nut
3.11 Using a suitable M5 screw, fully compress the blind captive nut. Remove the M5 screw.
3.12 Install a washer
the hole in the strap anchor is oriented so that the karabiner
Installing a carrying strap
(7)
on the underside of the tripod bowl, ensuring it is correctly
(4)
into the hole in the lower moulding.
(3)
on the lower strap anchor
(4)
into the hole in the lower moulding.
(3)
on the lower strap anchor
First
Page
(2)
and screw into the captive nut (4). Ensure that
(1.1)
can be attached
(1)
to the strap anchors and adjust to length.
(2)
and screw into the captive nut (4). Ensure that
(1.1)
can be attached
Previous
Next
Previous
Page
Page
View
(6)
supplied with
(5)
using a suitable tool.
(5)
using a suitable tool. If
108

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents