Vinten Vision Pozi-Loc Maintenance Manual page 106

Contents
Replacing tripod legs (150 mmEFP tripods)
Introduction
1 The legs are secured in the bowl assembly by clamp plates. Each clamp plate is secured by a single
screw.
Consumables
2 The following adhesive will be required:
Loctite 221 (Vinten Part No. Z002-026)
Removal
3 Remove the tripod leg as follows:
3.1 Remove two screws
3.2 Pull off the tripod leg (1). Note orientation and remove two pivot washers (4).
Installation
4 Install the tripod leg as follows:
4.1 Install two two leg pivot washers
NOTE: Do not apply any lubricant to the bowl, the leg trunnions, leg pivot friction rings or
washers.
4.2 Position the leg in the bowl (5).
4.3 Install the leg pivot clamp plates
screws (2) so that the leg is self-supporting when set at 45°.
(2) and leg pivot clamp plates
(4) on the tripod leg (1), oriented as noted in removal
(3) and secure with screws (2), using Loctite 221. Tighten
First Previous
Page Page
(3) securing the tripod leg
Next Previous
Page View
(1) to the bowl (5).
106