Vinten Vision Pozi-Loc Maintenance Manual page 101

Contents
Assembly - earlier clamps
13 Install the bottom clamp as follows:
13.1 Apply white bearing grease to the cam surface of the cam moulding
13.2 Install the washer (6), the bottom clamp shaft (16), the cam moulding
assembly (9) in the bottom clamp moulding (11).
14 Install the oval leg as follows:
14.1 Insert the oval leg
of the lower clamp assembly (9).
14.2 Position the T-piece buffer
(2).
14.3 Refit the screw cover (1).
15 Install the clamp knob as follows:
15.1 Position the clamp knob
to the 'OFF' position.
15.2 Install the adjusting grubscrew
16 Adjust the clamp.
(10) in the bottom clamp moulding (11), taking care not to damage the surface
(4) and T-piece cap
(12) on the bottom clamp shaft
(17)
See "Adjusting 'Pozi-Loc' leg clamps" on page 89.
(3) on the oval leg tube
(16)
in the bottom clamp shaft (16).
First Previous Next
Page Page Page
(8) and the washer (6).
(8) and the lower clamp
(10) and secure with screw
and turn the knob counter-clockwise
Previous
View
101