Philips HR7600/10 Recipes & Directions For Use page 8

ENGLISH
8
C
4 Make sure the motor unit is switched off
(speed setting '0'). Press the release
buttons and attach the motor unit by first
inserting its rear end into the handle of
the bowl.
C
1
5 Then lower the front part of the motor
unit onto the lid, until you hear a click.
2
C
6 Place the pusher into the feed tube.
To prevent ingredients from escaping through the
feed tube, use the pusher to close the feed tube.
Use the feed tube to add liquid and solid
ingredients.
Use the pusher to push ingredients through the
feed tube.
Put the plug in the wall socket.The appliance is
ready for use.
C
7 The speed control allows you to choose
the right setting to obtain optimal results.
Pulse setting: for pulse operation. If the Pulse
B
button is pressed the appliance runs at maximum
speed.The appliance stops running when the
button is released.
setting 1: for normal speed.
B
setting 0: for switching the appliance off.
B
When you have finished processing, you can
only remove the motor unit (and the lid) after
you have switched the appliance off.
The release buttons cannot be pressed in when
the appliance is switched on.
1
C
8 To remove the motor unit, press the
release buttons and lift the motor unit
from the lid of the bowl.
Blade
The blade can be used for chopping, mixing,
blending, pureeing and preparing cake
mixtures.
C
1 Place the tool holder in the bowl.
C
2 Remove the protective cover from the
blade.
The cutting edges of the blades are very sharp
Avoid touching them!
C
3 Put the blade onto the tool holder.
4 Put the ingredients into the bowl. Pre-cut
large pieces of food into pieces of approx.
3 x 3 cm.
See the table for the recommended settings.
Processing takes 10 - 60 seconds.
5 Close the lid and attach the motor unit.