Monitor Installation - Fermax VIDEO DIGITAL COLOR KIT Manual

MONITOR INSTALLATION

The CityMax monitors allow a quick and easy installation, without neccesity
of doing any kind of building-work. Do not remove the screen protection film
until the Monitor is completely installed.
1.Use a plain screw-driver to separate the
base from the Monitor. Put it in, rotate
and slide the Monitor up.
3.Once the wires are connected, plug in
the connector and place the Monitor as
shown above: 1 - 2 - 3 .
Once the equipment is fully installed, the Monitor will need to be programmed
in order to assign it a call pushbutton. Follow the set up sequence shown in
page 32.
Pag 28
2.Install the Monitor on a hard and flat
surface. Mark and drill the wall at the
holes in the base.
4.To unhook the Monitor, insert the screw-
driver in the notch , turn it a few degrees
and slide up the Monitor.