Outdoor Panel Setup; Monitor Configuration; Operation - Fermax VIDEO DIGITAL COLOR KIT Manual

MONITOR CONFIGURATION

Before programming, the system must be fully wired, the handset on hook
and the Monitor connected as shown below.
J1
1.Put the jumper J1 to the
PRG position.
confirmation sound will
be heard.
Time between steps 1 and 2 must not be longer than 2 minutes. In case this
would occur, put back the jumper to its original position and restart the sequence.

OPERATION

Once the VIDEO DIGITAL COLOR KIT has been installed, it is advisable to
check all its features.
Call
* When pressing the call pushbutton in the Outdoor Panel it produces an
electronic sound in the Monitor, which is activated to show the visitor in
the screen. The image must be clear, day and night, because of the
camera's lighting. You can watch the visitors without letting them know if
the apartment is inhabited.
Pag 32
PRG
2.Press the button which
A will identify the Monitor.
Once again confirmation
is generated.
J1
3.Put back the jumper
back to its original
position and hang up the
Monitor.
PRG