How To Add An Outdoor Panel - Fermax VIDEO DIGITAL COLOR KIT Manual

it has been installed (see page 32), assigning one of the pushbuttons in
the Outdoor Panel.
* The resistor in the connector must be cut in all the monitors with 2 coaxial
cables connected. Do not cut it when only one coaxial is connected.
Do NOT cut the resistor.
How to add an Aditional Outdoor Panel
It is possible to extend the DIGITAL KIT by installing an Aditional Outdoor
Panel at another access to the building (service gate, garage, etc...). Depending
on the type of aditional Panel (video or audio) you will be able to use the
ADITIONAL VIDEO PANEL KITS (REF.6075, REF.6077 Y REF.6079) and
ADITIONAL AUDIO PANEL KITS (REF.6056, REF.6057 Y REF.6058) for 1, 2
and 3 lines respectively.
The wiring of these ADITIONAL PANEL KITS are idependent from the number
of lines. Therefore, the diagrams shown can be used for every VIDEO DIGITAL
COLOR KIT.
ADDITIONAL PANEL
Wiring for ADDITIONAL COLOR VIDEO PANEL KITS
NOTE:
Terminals can only be programmed from the main panel (JP1 connected).
VIDEO DIGITAL COLOR KIT manual
TO THE MONITOR
Do not
connect
JP1
Cut the resistor.
FLAT MONITOR HIGH RESOLUTION
HIGH RESOLUTION CCD CAMERA
PAN &TILT
Connect
JP1
MAIN PANEL
CCD CAMERA HIGH RESOLUTION
PAN &TILT
Pag 39