Table of Contents
Advertisement
DETECTA-6
DETECTA-6
MONITOR INSTALLATION
Assembly
ADS monitors require simple programming for correct functioning. See the section
Programming the ADS Monitor
4+N monitors do not require programming.
In MDS installations, it is the audio decoder, to which the 4+N monitor is connected, that
must be programmed (see manual supplied with the decoder)
ADS
MONITOR PROGRAMMING
1
1. With the monitor connected, set the J1 switch in the PRG position. You will hear a confirmation tone.
2. Press the house call button. The confirmation tone is heard again.
3. Insert the switch in its original position and put the Monitor in place.
* The monitor will not work until it has been programmed.
Pag 20
2
< 2 min
Dismantling
3
Advertisement
Table of Contents
