Installation Instructions; Touch Panel (Tp); Power Module (Pm) - Truma Vicon 2 Installation Instructions Manual

Power module/touch panel
Table of Contents

Advertisement

Available languages

Available languages

Installation instructions

Installation in vehicles must accord with the technical and
administrative provisions of the individual country of use (e.g.
EN 1648, VDE 0100-721). The national legislation and regula-
tions must be observed.
In other countries always observe the respectively valid
regulations.

Touch Panel (TP)

Max. 1 Touch Panel can be connected per installed
Vicon 2 bus system using a Y-adapter (Y).
Install the Touch Panel in a place protected against moisture
and wetness.
Produce an installation opening for the Touch-Display.
max. 3
148
All dimensions in mm.
Plug in the cable from the Y-adapter (e.g. at plug X 1).
It is compulsory that the open plug X 2 is closed off with a
terminating resistor R = 120 Ω (part no. C30000-00300).
A cable outlet is possible to the side or top.
Insert the cable for strain relief into the cable guide.
X 2
X 1
Push the cable through the installation opening and lay to
the Y-adapter.
Fix the Touch Panel with 4 screws (max. 3 mm outer diam-
eter, max. torque 1 Nm).
Press the frame onto the Touch Panel until it clicks in place.
8
125
X 2
X 1
≤ 1 Nm

Power Module (PM)

Install the Power Module in a place (wall or floor) protected
against moisture and wetness.
The Power Module must be installed in a freely accessible
position without disturbing any cover elements etc.
In order to allow easier servicing, Truma recommends
installing a freely accessible diagnosis plug (part no.
C30000-00400) in the system instead of a terminating
resistor.
Installation dimensions
170
170
All dimensions in mm.
Removing the housing cover
1
Minimum installation space
To detach the housing cover, a suitably sized access opening
must be available inside. Maintain a minimum clearance of
15 mm to the housing cover if the access is closed.
Fix the device with 2 screws (no countersunk screws, max.
torque 1 Nm). ´
≤ 1 Nm
154.5
Ø 4,5
310
All dimensions in mm.
36.3
1
2
3
70
52

Advertisement

Chapters

Table of Contents
loading

Table of Contents