Benchmark Scientific Bioclave Operation Manual page 7

5.4.2 Start the sterilization program.
Press START button, the machine will begin the cycle automatically.
It will take 30-75 minutes. (See Appendix 2)
F
Caution: When you press the START button but the door has not been
fully closed. You will see the
A cycle can not be started until you close the door to the max.
position and press the "Start" button again.
5.4.3 Sterilization cycle completion
After a cycle is completed, the printer will be activated and print out a
report of the cycle settings (if the optional printer has been connected).
After the pressure returns to 0, the door is unlocked and the materials
can be removed.
9
total time or
count down until
completion
blinking on the screen.
F
Instructions manual
Always use the tray handle to load or unload the tray into the
autoclave. Failure to do so can result in burning.
If you need to interrupt a cycle and remove materials urgently.
you may hold the START button for 3 seconds after completing
sterilization time to skip the dry cycle.
This will result in the program skipping directly to the last step
and eliminate the drying stage. After one minute the cycle
will end.
Instructions manual
1 0