Operation; Setup; Preparation Of Sterilization Materials - Benchmark Scientific Bioclave Operation Manual

5 Operation

5.1 Setup

5.1.1 Open the door and remove all of the inner contents for unpacking.
5.1.2 Connect the power cord to an outlet of the appropriate voltage
5.1.3 Power on
The switch is located underneath the control panel
on the front side of the machine .
After switching on, the machine turns on the LCD
and shows the door position, water level,
working program, date, time and etc.
Temperature
Pressure
Distilled water tank is requires water.
Distilled water tank is full
Used water tank is full.
Door locked
information output to USB port
Printer is connected
Notice: Before using the sterilizer or at any time the low water
icon blinks, it is necessary to fill the distilled water
tank with distilled water.
5
Program
F
Alarm code
F
process curve
F
Setting
Time
Date
Instructions manual
5.1.4 Filling the distilled water
Remove the cover, and fill the tank with distilled water.
When you hear a beep signal, it means the water level exceeds the
max. level. The will be displayed. Please stop filling immediately.

5.2 Preparation of sterilization materials

For the most effective sterilization and to preserve the sample, please
follow below:
* Arrange the samples of different material on different trays or with at least
2in. of space between them.
* Always insert a sterilization paper or cloth between the tray and sample,
to avoid direct contact between the different materials.
Instructions manual
The water level should not
exceeded this port.
6