Table of Contents
Advertisement
07/
Bed Levelling
1.
Tighten the four levelling nuts at the bottom of the platform
before initial levelling.
2.
Select Settings→Levelling, click on the number ①.
3.
Adjust the platform height by turning the knob underneath. Use
a piece of A4 paper (standard printer paper) to assist with the
adjustment, making sure that the nozzle lightly scratches the
paper.
4.
Complete the adjustment of the screw on all 4 corners.
5.
Click the number ⑤ to test whether the middle gap of the
platform is suitable.
6.
Repeat above steps 1-2 times if necessary.
3
4
5
1
2
The nozzle is too far away
from the platform, so the
c o n s u m a b l e s c a n n o t
adhere to the platform.
Filament are extruded evenly,
just sticking on the platform.
The nozzle is too close to
t h e p l a t f o r m , a n d t h e
filament are not extruded
enough, even scraping the
platform.
Hide quick links:
Advertisement
Table of Contents
