Advertisement
In a few seconds, the mirror will
begin to darken.
c) Remove the cover from the forward looking
photo cell and the mirror will begin to clear.
d) Verify that either a direction, such as NE, or
"C" is displayed in the display window. If not,
ensure the feature is turned ON by pressing the
NOTE
!
Time to darken will vary with ambient light level.
4. Turn the ignition key to the OFF position.
5. Push each HomeLink ® button, one at a time, and
verify that LED indicator to the left of the center
switch illuminates with a red LED. (Fig. 6-2)
6. Testing is now complete.
7
Installation of Removed Components
1. Trim excess off all wire ties.
2. Reinstall in reverse order, all trim pieces removed
during installation.
3. Place User Guide in vehicle glove-box.
(Fig. 7-1)
4. Remove fingerprints, smudges, dirt, etc. from mirror.
5. Verify each reinstalled component for proper fit and
function.
8
Compass Zone Adjustment (Dealer Install ONLY)
1. Adjust compass zone after EC mirror installation.
a) The zone setting is factory preset to Zone 8.
Refer to Compass Calibration Zone Map
(Fig. 8-1) to find correct compass zone setting
for your geographical location. Use same map
from User Guide.
b) To change the zone setting, push and hold the
right button until a number appears in the display.
Press button repeatedly until desired compass
zone number is reached.
Page 7 of 8
button.
Fig. 6-2
Fig. 7-1
Fig. 8-1
Revision A
HomeLink Buttons
Red LED
User Guide
1
2
2
3
4
5
3
6 7
8
9
10 11
4
5
6
8
7
15
14
14
13
12
13
12
11
10
9
550-0336
Advertisement
