Advertisement
2
EC Mirror Installation
1. Plug 10-pin connector into back of EC mirror.
(Fig. 2-1)
NOTE
!
Slide harness sleeve as close to mirror connector as possible.
2. Attach EC mirror.
a) Hold the mirror head and slide the mount
downwards as far as possible over the windshield
button, until fully seated.
b) Using a #T20 Torx, tighten the mirror mounting
bracket screw to 1.3 ft-lbs (17.8 kg-cm).
(Fig. 2-2)
3
Route EC Mirror Harness to Vehicle Power
1. Route EC harness from mirror to headliner.
a) Route power harness into groove of wire
cover and attach wire cover to mirror base.
(Fig. 3-1)
b) Slide upper portion of wire cover up to headliner
so the "forks" are held by the headliner.
(Fig. 3-1)
2. Route EC harness to driver-side A-pillar.
a) Route power harness between vehicle headliner
and roof to top of driver-side A-pillar area.
(Fig. 3-2)
Page 4 of 8
Fig. 3-2
Revision A
Fig. 2-1
1.3 ft-lbs
Fig. 2-2
Fig. 3-1
550-0336
Advertisement
