Cleaning The Machine - Fayat Group BOMAG BPR 35/60 Operating Instruction, Maintenance Instruction

8.10.2

Cleaning the machine

NOTICE!
Components can be damaged by water
entering into the system!
– Do not direct the water jet directly into the air
filter, carburettor, recoil starter, air intake or
starter switch.
1.
CAUTION!
Danger of eye injuries caused by particles
flying around!
– Wear your personal protective equipment
(safety gloves, protective working
clothes, goggles).
Spray the engine with a suitable, non-inflammable cleansing
agent, let is soak in for a while, clean it off with water and
blow out with compressed air.
2. Warm up the engine for a while to avoid corrosion.
3. Look for the cause of oily contamination and have any leaks
sealed by our customer service.
NOTICE!
Danger of engine damage caused by reduced
cooling!
– Immediately seal any oil or fuel leaks near fuel
tank, cylinder or cooling air intake.
1. Park the machine in secured condition
'Parking the machine in secured condition' on page 57.
2. Allow the engine to cool down for at least 30 minutes.
NOTICE!
Components can be damaged by water
entering into the system!
– Do not direct the water jet directly into the air
filter, carburettor, recoil starter, air intake or
starter switch.
3. Clean the machine with a water jet.
4. Run the engine warm for a while to avoid corrosion.
BPR 35/60
Maintenance – As required
Ä Chapter 6.4
95