Festo MPA-FB Series Manual page 16

Contents and general instructions
Term/abbreviation
Basic components
Components
Connecting the tubing
Cover plate
CPX module
CPX terminal
Electric supply plate
Electronic module
End plate
Exhaust plate
Sub−base
I/O
Isolating seal
XIV
The following product−specific terms and abbreviations are
used in this manual:
Meaning
Component (pneumatic interface, multipin sub−base, pneumatic
sub−base or pneumatic supply plate) on which further components
(exhaust plates, large surface−mounted silencers, pressure regulators,
valves or cover plates) are fitted
Common term for pneumatic interface, multipin sub−base, exhaust
plate, large surface−mounted silencer, pneumatic sub−base or
pneumatic supply plate, electric supply plate, pressure sensor plate,
proportional pressure regulator, end plate, pressure regulator plate,
valve and cover plate
Connecting the pneumatic supply lines (tubing) to the MPA−S valve
terminal
Plate without valve function for sealing non−used valve locations on
sub−bases
Common term for the various modules which can be incorporated in a
CPX terminal
Modular electric terminal type 50 or type 53
Plate for additional supply of the valves with load voltage
Module in the sub−base with LED and valve coil management
Extreme right−hand plate of the MPA−S valve terminal and extreme
left−hand plate of the CPX terminal with holes for fitting onto a wall
Plate for ducted exhaust with connection 3/5
Plate for 4 valve locations for single−solenoid, double−solenoid or
mid−position valves, with work connections 2 and 4
size MPA1 (type MPAS...4) with 4 valve locations
size MPA2 (type MPAS...2) with 2 valve locations
Input/Output modules
Special seals for forming pressure zones
Festo P.BE−MPA−EN en 0802c