Festo MPA-FB Series Manual page 157

5. Maintenance and conversion
Fitting
1
Multipin
sub−base
2
Guide pins
3
Seal
4
Pneumatic
sub−base
Fig. 5/14: Fitting the multipin sub−base
Festo P.BE−MPA−EN en 0802c
Proceed as follows:
1. Make sure the seals are not damaged. Replace the seals if
they are damaged.
2. Place the seal onto the guide pins of the multipin
sub−base.
1
2 3
3. Pull the multipin sub−base away from the pneumatic
sub−bases. Make sure that the seal and the components
are correctly positioned.
2
4
5−29