Table of Contents
Advertisement
|
|
|
|
|
|
|
|
|
|
|
|
|
|
34
Installation Guide
buttons within 60 seconds, the menu changes to display the charging progress.
You can switch the front panel display to the menu at any time by pressing
the select button again.
5. Keep pressing and releasing the up or down button until the Node: option is
displayed in line 1 of the front panel display.
6. Verify that the node number that is displayed in line 2 of the display is the
same as the node number that is printed on the front panel of the node (see
Figure 36).
N o d e :
x x x x x x
Figure 36. Node number
The XXXXXX in Figure 36 represents the node number. If the numbers do not
match, exchange the Front Panel FRU on the SAN Volume Controller.
7. Keep pressing and releasing the up or down button until the Ethernet option
is shown on the front panel display. Line 2 of the front panel display shows
the message Inactive. This message shows that, although an Ethernet
connection is available, it cannot yet be used (see Figure 37).
E t h e r n e t :
I n a c t i v e
Figure 37. Ethernet mode
8. Keep pressing and releasing the up or down button until the FC Port-1 option
shows in the display.
9. Check whether line 2 of the display shows the message Active.
10. Keep pressing and releasing the left or right button to display the other port
options. Check whether for each port, line 2 of the display shows the message
Active. If Active is not shown for any port, go to MAP 5600: Fibre-channel to
repair the fault.
11. If the configuration data table provided by the customer indicates that the
SAN Volume Controller nodes are to be operated at 1 Gbps, press and hold
the down button; press and release the select button. Release the down button.
The second line of the display will show the current fibre channel speed
setting of the node. Press the up or down button until 1 Gbps is displayed
and then press the select button. This changes the fibre channel speed for all
ports on this node to 1 Gbps.
12. If you want to select a language other than English, perform the following
steps:
a. Press the up or down button until Select Language? displays.
b. Press the select button.
c. Press the left or right button until the required language is displayed.
d. Press the select button.
13. Repeat steps 1 through 12 for each SAN Volume Controller.
14. When the battery is fully charged, the charge progress bar is replaced by the
Cluster option on the front panel display of the SAN Volume Controller.
Advertisement
Table of Contents
