Table of Contents
Advertisement
|
|
|
|
|
|
Chapter 4. Installing the uninterruptible power supply, the master console, and the SAN Volume Controller
7. Select the Loopback data test option and press Enter.
8. Select the Continue with loopback data test option and press Enter. One of the
following messages is displayed:
v
Loopback Data Test failed
If this message is displayed, either try a different fibre channel cable or
replace the fibre channel HBA to correct this problem.
v
Press any key to stop the Loopback Data Test
Press Enter twice to get back to the Fast!UTIL Option List
Select Exit Fast!UTIL
9. Remove the fibre channel cable that you installed between the two ports on the
fibre channel HBA.
10. Restart the machine to start the Windows
a. Enter administrator in the User ID field.
b. Enter passw0rd in the password field; this password applies to all required
password fields.
c. The master console continues booting.
Note: This process can take several minutes before all services are started
and operations are completely responsive.
11. Refer to the IBM TotalStorage SAN Volume Controller: Planning Guide for the
customer-completed configuration data table and connect the fibre-channel
cables from the master console as specified in that table.
Note: You will also use the configuration data table for steps 12 and 13.
12. To enter the master console IP address provided by the customer, complete
the following steps:
a. Right-click the My Network Places icon and select Properties
b. Right-click the Local Area Connection 2 option and select Properties.
c. Select Internet Protocol (TCP/IP) and select Properties
d. Enter all required information for the IP and DNS addresses.
e. Connect Ethernet port-2 to the users network.
13. To enter the master console name provided by the customer, complete the
following steps:
a. Right-click the My Computer icon and select Properties.
b. Select the Network Identification tab and select Properties.
c. Enter the master console name.
d. Select the More button.
e. Enter the full path information in the Primary DNS suffix of this computer
field.
f. If the customer needs Remote Support, perform step 12 again for Local
Area Connection and connect an Ethernet cable from Ethernet port 1 on the
master console to the designated connection (for example, Firewall DMZ
Port). For more information on configuring a Remote Support, go to the
following Web site and select the Enhanced Remote Support topic:
www.ibm.com/storage/support/2145
g. Restart the master console.
14. Attach a RID tag to the master console using machine type 2145 and the serial
number of the SAN Volume Controller that is being installed with the master
console.
®
operating system:
25
Advertisement
Table of Contents
