Table of Contents
Advertisement
|
|
|
Create cluster?
Select
Delete cluster?
Up (hold)+ select
IP address
Subnet mask
Figure 48. Create cluster? menu sequence
Press the left and right buttons to navigate through the secondary options that are
associated the create cluster option. When you have navigated to the desired
option, press the select button. The secondary options available include:
v IP address
v Subnet mask
v Gateway
v Create now?
IP address:
The IP address lets you display or change the Ethernet IP address for the cluster
that you are going to create. Be sure to verify the correct IP address with the
customer before you create a cluster.
Attention: If you change the IP address, ensure that you type the correct address.
Otherwise, you cannot access the cluster using the command line tools or a web
browser.
Perform the following steps to change the IP address:
1. From the Create Cluster? option, press the select button. The IP address option
displays.
2. Press the select button again. The first IP address number is highlighted.
3. Press the up button if you want to increase the value that is displayed; press
the down button if you want to decrease that value. If you want to quickly
increase or decrease the value, hold the up or down button, respectively.
4. Press the right or left buttons to move to the number field that you want to
update.
5. Repeat steps 3 and 4 for each number field that you want to update.
6. Press the select button to complete the change.
Press the right button to display the next secondary option or the left button to
display the previous options.
Subnet Mask:
Chapter 5. Using the front panel display on the SAN Volume Controller
Gateway
Create now?
Select
Password
Create failed
43
Advertisement
Table of Contents
