Table of Contents
Advertisement
CAUTION:
The electronics assembly weighs 6.4 kg (14 lb). Take care when you remove
it from the uninterruptible power supply.
1
Figure 23. Removing the uninterruptible power supply electronics assembly
4. Pull the electronics assembly 2 out of the uninterruptible power supply, and
put it to one side.
5. Stand at the front of the rack and, with aid from another service
representative, place the back of the uninterruptible power supply onto the
support rails, then slide the uninterruptible power supply into the rack.
6. Install the front flathead screws 1 (see Figure 24 on page 22).
Chapter 4. Installing the uninterruptible power supply, the master console, and the SAN Volume Controller
2
21
Advertisement
Table of Contents
