INSTALLATION INSTRUCTIONS VOLT Estate Size Path & Area Lights ® 3601 Series Important: Please Read Before Installation This fixture is intended for installation in accordance with local codes and the National Electric Code (NEC). Failure to adhere to these codes and instructions may result in serious injury, property damage and void the warranty.
Page 4
INSTALLATION INSTRUCTIONS VOLT Estate Size Path & Area Lights ® 3601 Series Remove Stem Top Loosen the stem top and remove it from the top end of the stem. Stem Top Stem Install Bulb Insert the bulb with the correct...
Page 5
Install Stem Top Thread the stem top onto the stem and hand tighten until Stem Top snug. Stem Install Stake Ground Level Stake Stabilizer Stake Grid Dig a hole in the ground for the stake. Slide the stabilizer grid onto the stake and secure with the screws.
Page 6
INSTALLATION INSTRUCTIONS VOLT Estate Size Path & Area Lights ® 3601 Series Remove Cap from Stake Remove the cap from the stake by loosening the set screws. Set Screw Stake Install Cap to Base Screw the coupler on the bottom center of the base and then thread the cap onto the coupler.
Fixture Installation Pass the supply wires through the stake. Attach the cap with the fixture onto the stake and secure with the set screws. Hand tighten until snug with a screwdriver. Set Screw Stake Supply Wire Wire Connection Wire Connectors Pigtail Main Supply Cable Strip both leads from the luminaire pigtail.
Page 8
INSTALLATION INSTRUCTIONS VOLT Estate Size Path & Area Lights ® 3601 Series Install Hat Finial Finial Stem Top Stem Top Stem Top OPTIONAL A OPTIONAL B OPTIONAL C Place the hat onto the stem top and secure it with the finial, or thread the hat onto the stem top directly.
Need help?
Do you have a question about the 3601 Series and is the answer not in the manual?
Questions and answers