Table of Contents
Advertisement
S
ETUP
Remote Device Management (RDM)
Remote Device Management, or RDM, is a standard for allowing DMX-enabled devices to communicate
bi-directionally along existing DMX cabling. Check the DMX controller's User Manual or with the
manufacturer, as not all DMX controllers have this capability. The Ovation E-910FC IP supports RDM
protocol that allows feedback to make changes to menu map options.
Master/Slave Connectivity
The Master/Slave mode allows a Ovation E-910FC IP (the master) to control one or more Ovation E-
910FC IP products (the slaves) without a DMX controller. One Ovation E-910FC IP becomes the master
when running an auto or custom program, or by being in a Static mode.
Each slave's control panel must be configured to operate in Slave mode. During Master/Slave operation,
the slaves will operate in unison with the master.
DO NOT connect a DMX controller to products operating in Master/Slave mode. The
DMX controller signals may interfere with the signals from the master.
The
Operation
configure the master and slaves.
Use IP65 data cables to preserve the IP65 rating and the warranty of this product.
Mounting
Before mounting the product, read and follow the safety recommendations indicated in the
For our CHAUVET Professional line of mounting clamps, go to http://trusst.com/products/.
Orientation
Always mount this product in a safe position, making sure there is adequate room for ventilation,
configuration, and maintenance.
Rigging
Chauvet recommends using the following general guidelines when mounting this product.
•
Before deciding on a location for the product, make sure there is easy access to the product for
maintenance and programming purposes.
•
Make sure that the structure onto which the product is being mounted can support the product's
weight. See the
Technical Specifications
•
When mounting the product overhead, always use a safety cable. Mount the product securely to a
rigging point, whether an elevated platform or a truss.
•
When rigging the product onto a truss, use a mounting clamp of appropriate weight capacity.
•
When power linking multiple products, mount the products close enough for power linking cables to reach.
•
The bracket adjustment knobs allow for directional adjustment when aiming the product to the desired
angle. Only loosen or tighten the bracket knobs manually. Using tools could damage the knobs.
Procedure
The Ovation E-910FC IP comes with a double-bracketed yoke that can be used as a floor stand or to which
mounting clamps can be attached for hanging. Mounting clamps must be purchased separately. Ensure that the
clamps can support the weight of this product. Use at least one mounting point per product where necessary.
Mounting Diagram
Safety cable
(such as CH-05 from
Chauvet)
Ovation E-910FC IP User Manual Rev. 4
section of this manual provides detailed instructions on how to
for weight information.
Safety
Notes.
Mounting clamp
(such as CTC-50 or CTC-50HCN
from Chauvet)
Page 7 of 31
Advertisement
Table of Contents
