Chapter 5 Operation; Switching At The Device - Gude Expert Power Control 1000 Manual

Expert Power Control 1000 / 1001
4.3.7.1 Enable Syslog
Here you can activate Syslog of Expert Power Control 1000 / 1001.
4.3.7.2 Syslog Server IP
If syslog is active enter here the IP address of you Syslog server.
4.3.7.3 Syslog Port
If syslog is active enter here the port number, that your Syslog server uses to receive syslog information.
More information about Syslog you can find in chapter Syslog, on http://www.gude.info/wiki or ask our support team.
5 Operation
5.1

Switching at the device

On the front of Expert Power Control 1000 / 1001 a button is located. When the device is running, you can change the
Power Port status by pushing this button. The LED on the upper side of fthe device indicates the recent switching status
(green=enabled/red=disabled).
13
Configuration