AQ105 kit is supplied with 30 to 50 litre models.
AQ108 kit is supplied with 80 to 100 litre models.
Both kits include:
•
Cold inlet assembly comprising pressure reducing valve with integral line strainer and
expansion relief valve with check valve, expansion vessel take off and balanced cold
water take off.
•
Expansion vessel and wall fixing bracket.
•
Wall locating bracket.
•
Tundish.
Cold inlet set
Expansion relief valve
Discharge to
tundish
Cold supply
to cylinder
Expansion vessel take off
Fig. 2
Internal check valve
•
The Aquapoint shall be installed as close as possible to the outlets.
•
When installing the Aquapoint in a room with a bathtub or shower, take into account the
requirements defined in IEC Standard 60364-7-701 (VDE 0100, Part 701).
•
The Aquapoint has to be fitted to the wall using appropriate wall screws with a minimum
diameter of 8mm.
•
A wall with a poor load-bearing capacity must be properly reinforced where the Aquapoint
will be installed.
•
The AP4 model may only be mounted vertically.
•
To facilitate future service interventions, you are advised to install the heater in accordance
with the installation measurements (see Fig. 3 and Fig. 7).
Installation instructions & user manual
T210023 v1.02 NOV 2018 - ZIP AP430S-AP4100S
Components supplied with the unit for site fitting
Installation
Tel: 0345 6 005 005 email: service@zipindustries .co.uk www.zipwater.co.uk
Pressure reducing valve
(inc. line strainer)
Cold mains in
Balanced cold take off
Technical support
9