General Information - oventrop mote 200 Operating Instructions Manual

„mote 200"
1.

General information

The original operating instructions were drafted in
German.
The operating instructions in other languages have
been translated from German.
1.1 Validity of the operating
instructions
These operating instructions are valid for the
"mote 200" electronic wireless thermostat.
1.2 Type plate
The type plate is located in the battery case.
1.3 Extent of supply
Please check your delivery for any damage caused
during transit and for completeness.
Items supplied:
• 1× "mote 200"
• 1× operating instructions
• 1× adapter screw
• 3× adapters (Danfoss RA, RAV, RAVL)
• 2× batteries – 1.5 V LR6/Mignon/AA
1.4 Contact
Contact address
OVENTROP GmbH & Co. KG
Paul-Oventrop-Straße 1
59939 Olsberg
www.oventrop.com
GERMANY
Technical services
Phone: +49 (0) 29 62 82-228
1.5 Copyright and protective rights
These operating instructions are protected by
copyright. They are exclusively designed for persons
involved with the product.
1.6 Declaration of conformity
Oventrop GmbH & Co. KG hereby declares that this
product complies with the basic requirements and
other relevant provisions of the EC Directives con-
cerned.
The declaration of conformity can be obtained from
the manufacturer.
115096180#EN-V04.01.2020
1.7 Symbols used
Highlights important information and further
explanations.
f Action required
• Enumeration
1.
Fixed order. Steps 1 to X.
2.
Result of action
Z
2. Safety-related information
2.1 Normative directives
Observe the legal requirements applicable at the
installation location.
The current standards, regulations and guidelines
apply.
2.2 Correct use
Operating safety is only guaranteed if the product is
used correctly.
The Oventrop "mote 200" is a programmable, elec-
tric wireless thermostat designed to control radiators
in enclosed spaces. Use the product in dry, dust-free
environments without direct sunlight only.
Any other use of the product will be considered unin-
tended use.
Claims of any kind against the manufacturer and/or
its authorised representatives due to damage caused
by incorrect use will not be accepted.
Observance of the operating instructions is part of
compliance with correct use.
2.3 Modifications to the product
Modifications to the product are not permitted. In the
event of modifications to the product, the warranty
will become void. The manufacturer will not accept
liability for damage and breakdowns caused by mod-
ifications to the product.
General information
5