Maintenance; Removal And Disposal; Removal; Disposal - oventrop mote 200 Operating Instructions Manual

Maintenance

MALFUNC-
CAUSE
TION
The "Installation/ Fitting error,
Removal" LED adaptation not
flashes perma- possible.
nently (adap-
- The "mote
tation process
200" has not
failed).
been fitted to
the radiator.
- The valve lift is
too short.
- No valve
movement
possible.
10. Maintenance
NOTICE
Damage to surfaces caused by aggressive
detergents
f Do not use any hard or sharp objects,
abrasive powders or detergents that
dissolve plastic when cleaning.
f If required, clean surfaces with a soft
cloth. When dealing with more severe
dirt, moisten the cloth slightly with water
or use a mild detergent. Do not exert any
pressure on the LED display.
14

11. Removal and disposal

REMEDY

11.1 Removal

Fit the "mote
200" correctly to
f Open the menu by pressing "MENU" briefly once.
a radiator.
f Use the "PLUS"
f Confirm by pressing "OK/Set" briefly once.
Z The LEDs flash in sequence.
f Wait until the LED for the "Installation/Removal"
f You can now remove the "mote 200" by loosening

11.2 Disposal

Directive 2012/19/EU WEEE:
Directive 2006/66/EC:
and "MINUS"
the "Installation/Removal"
function flashes.
the collar nut.
Old appliances must not be disposed of with
standard waste, but must be dropped off at
a collection point for the recycling of electri-
cal and electronic appliances.
Do not dispose of batteries or rechargeab-
le batteries with standard waste.
The following symbols may be listed be-
low the symbol for separate collection:
• Cd = contains more than 0.002% cad-
mium by weight
• Hg = contains more than 0.005% mer-
cury by weight
• Pb = contains more than 0.004% lead
by weight.
„mote 200"
keys to select
function.
115096180#EN-V04.01.2020