Section 7: Regulatory - HID PIVCLASS M2000 Installation And Configuration Manual

7 Regulatory
The pivCLASS Authentication Module (PAM) is certified compliant with the following standards.
Federal Communications Commission (FCC) Part 15, Class A
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Industry Canada
This device complies with Industry Canada ICES-003. Operation is subject to the following two conditions: (1)
this device may not cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Le présent appareil est conforme aux ICES-003. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
UL 294 Access Control System Units
Listed for use only within the protected area.
Mount only in a UL 294 Listed sheet metal enclosure measuring not less than 16 x 16 x 3.5 inch (406 x
406 x 89 mm), such as the Bosch model D8103.
A UL Listed Tamper switch must be used in the enclosure.
The GPIO, Console and unused RS-485 ports were not evaluated by UL. No connections are supported.
PAM has been evaluated for use with pivCLASS and iCLASS SE readers and EdgePlus Controllers.
Connect only to a UL Listed ALVY or APHV, regulated, power limited power supply rated 12 to 24 V DC
(with an output voltage range of 10.2 to 26.2 V DC), 1.2 Amp minimum.
CE Marking
HID Global hereby declares that this product is in compliance with the essential requirements and other
relevant provisions of Directives 2014/30/EU (EMC) and 2014/35/EU (LVD).
January 2019
7
Section
39