Wiring Connections; Connecting Pam To Supported Reader Port; Connecting Pam To Pacs Panel Reader Port - HID PIVCLASS M2000 Installation And Configuration Manual

PLT-01628, Rev. D.2

4.5 Wiring connections

This section explains wiring the PAM to the PACS panel and supported reader(s).

4.5.1 Connecting PAM to supported reader port

Using a small flat-head screwdriver (1/8 inch or smaller), connect the Reader 1 or Reader 2 connector on the
PAM to the supported reader(s) according to the following table.
WARNING
Do not apply VDC to any connector from the reader other than +VDC.
Applying 12 V DC or greater to the GPIO lines may result in damage to the reader.
PAM Connections (READER 1 or 2)
TR+
TR-
R+
R-
GND (Ground)
VO (Voltage Out)

4.5.2 Connecting PAM to PACS panel reader port

Using a small flat-head screwdriver (1/8 inch or smaller), connect the PAM Wiegand 1 or Wiegand 2
connector (or both) to the PACS Panel Reader port. Reader 1 corresponds to Wiegand 1 and Reader 2
corresponds to Wiegand 2. See table below.
Note: Ensure connecting the correct connectors, since Wiegand 2 and 1 are flipped compared to Reader 1
and 2. See Section 4.3.1: PAM mounting dimensions.
PAM Connections (WIEGAND 1 or 2)
GND
D0
D1
BZR
LED
Note: Some PACS may have multiple LED wires, for example, red/green.
The PAM checks for a constant signal on the LED input (Green LED) indicating access granted by the PACS
after Wiegand is sent. If this signal is not received within one second of sending the Wiegand card number
and PIN then it will be considered access denied (this is the default setting for time-out and is configurable
for each PAM in the pivCLASS PACS Service). Any type of blinking or flashing signals from the panel are not
supported.
January 2019
Installing the module
Reader (Pigtail)
Red/Green
Tan
Gray
Pink
Black
Red
PACS Panel Connections (READER 1 or 2)
GROUND
DATA0/DATA
DATA1/CLOCK
BEEPER
GREEN LED
Reader (Terminal)
GPIO1 (P2-7)
GPIO2 (P2-6)
GPIO4 (P2-1)
GPIO3 (P2-2)
GND (P1-3)
+VDC (P1-4)
17