Section 4: Installing The Module; Checking The Package Contents; Installation Preparation - HID PIVCLASS M2000 Installation And Configuration Manual

4 Installing the module
This chapter describes installing, connecting and powering the pivCLASS Authentication Module (PAM).
CAUTION
ELECTROSTATIC SENSITIVE DEVICES
Observe precautions for handling

4.1 Checking the package contents

Before installing the PAM, unpack the contents of the shipping container and make sure that you have the items
listed.
Item
pivCLASS Authentication Module (PAM)
Secure Digital (SD) Card with PAM Firmware
(Note: Depending on configuration this may be pre-installed in the PAM)
Jumpers
Termination Resistors (118 ohm)

4.2 Installation preparation

Carry out the following:
1. Obtain an Ethernet cable or switch to connect the PAM. The choices are:
Crossover cable connects to the pivCLASS PACS Service Application (for configuration).
Straight-through cable connects to a hub or switch.
2. Prepare the UL294 Listed Enclosure.
3. Remove the PAM from its packaging.
Note: Ensure the SD Card is correctly seated.
January 2019
4
Section
Quantity
1
1
6
4
13