Applying Power; Disabling Power - HID PIVCLASS M2000 Installation And Configuration Manual

PLT-01628, Rev. D.2

4.8 Applying power

After attaching all PAM connections apply power and configure the PAM (see Section 5 PAM configuration).

4.9 Disabling power

For powering off the PAM, ensure all processes are complete and remove power.
CAUTION
Do not remove power to reboot, unless it is absolutely necessary, as data corruption on the SD
card may occur.
For PAM Configuration and setup, see Section 5 PAM configuration.
January 2019
Installing the module
19