Configure The Pam To Communicate With The Pacs Service - HID PIVCLASS M2000 Installation And Configuration Manual

5.4.2 Configure the PAM to communicate with the PACS Service

Follow the steps below to configure communication between the PAM and PACS Service.
1. Install the PAM and power it on.
2. Place the PAM into configuration mode:
1. Disconnect power from the PAM.
2. Set dip switch 1 on the PAM board to ON. PAM configuration mode is now enabled.
3. Reconnect power to the PAM.
3. Connect an Ethernet cable from a computer to the PAM (located on the bottom of the device).
4. Open a web browser and enter the following default url: https://192.168.0.222 (factory default; ensure
your computer is configured to the 192.168.0.x IP range). A subnet mask example is: 255.255.255.0.
At this point your browser will present you with a security warning. The PAM is a device, not an Internet
web site, and uses a self-signed certificate. Your browser cannot verify the owner of the self-signed
certificate.
Depending on your browser you may be instructed to click on an Advanced button to find an option to
proceed to the web site or add a security exception.
Note: A self-signed certificate still encrypts your connection making your data safe from eavesdroppers.
5. Enter the following login credentials and click Login.
Login: admin
Password: password
24
PAM configuration PLT-01628, Rev. D.2
January 2019