Power Up; First Time Power Up - Baldor DBSC 100 Series Installation And Operating Manual

Section
Several assumptions are made. These assumptions are:
Several assumptions are made. These assumptions are:
1. T h e system setup section assumes that all wiring has been completed.
1. The system setup section assumes that all wiring has been completed.
2. A l l power is still OFF.
2. All power is still OFF.
3. T h e DIP switch AS1 located on the DBSC panel (Figure 3-1) is properly
3. The DIP switch AS1 located on the DBSC panel (Figure 3-1) is properly
set.
set.
4. T h e jumper at SB 601-609 is correctly set.
4. The jumper at SB 601-609 is correctly set.

First Time Power Up

First Time Power Up
The following procedure is for the first time power up condition.
The following procedure is for the first time power up condition.
1. Disconnect the motor leads from X1-U, X1-V and X1-W. The initial
1. Disconnect the motor leads from X1-U, X1-V and X1-W. The initial
adjustments must be performed under a no load condition.
adjustments must be performed under a no load condition.
2. C o n t r o l must be disabled (X3-9 input, Figure 3-3 switch OPEN or AS1-8
2. Control must be disabled (X3-9 input, Figure 3-3 switch OPEN or AS1-8
must be in the OFF position).
must be in the OFF position).
3. M e a s u r e the input line voltage at the power disconnect device and ensure
3. Measure the input line voltage at the power disconnect device and ensure
that it is the correct voltage.
that it is the correct voltage.
4. B e sure a PC is connected to the serial communications interface (X6).
4. Be sure a PC is connected to the serial communications interface (X6).
5. I n s t a l l the software program on the PC hard disk drive as instructed in the
5. Install the software program on the PC hard disk drive as instructed in the
Software Manual.
Software Manual.
6. T u r n ON the input power to the control.
6. Turn ON the input power to the control.
4–4
4 - 4
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

Power Up

Power Up
MN1229
MN1229