Suzuki Ciaz Owner's Manual page 70

BEFORE DRIVING
WARNING
If you attempt to adjust the display
while driving, you could lose control
of the vehicle.
Do not attempt to adjust the display
while driving.
NOTE:
• Indications will change when you push
and release a knob.
• The display shows estimated values.
Indications may not be the same as
actual values.
Trip meter
The trip meter can be used to measure the
distance traveled on short trips or between
fuel stops.
You can use the trip meter A or trip meter B
independently.
To reset the trip meter to zero, push and hold
the trip meter selector knob (2) for a while
when the display shows the trip meter.
NOTE:
The indicated maximum value of the trip
meter is 9999.9. When you run past the
maximum value, the indicated value will
return to 0.0.
2-47
Instantaneous Fuel Consumption
If you selected instantaneous fuel con-
sumption the last time you drove the vehi-
cle, the display does not show the last
value of instantaneous fuel consumption
from previous driving when the ignition
switch is turned to the "ON" position or the
engine switch is pressed to change the
ignition mode to "ON". The display shows
the value only when the vehicle is moving.
NOTE:
• The display does not show the value
unless the vehicle is moving.
• Depending on the vehicle's specification,
the fuel consumption units of initial set-
ting are indicated as L/100km or km/L.
• For "L/100km" or "km/L" setting, the indi-
cated maximum value of instantaneous
fuel consumption is 30. No more than 30
will be indicated on the display even if
the actual instantaneous fuel consump-
tion is higher.
• The indication on the display may be
delayed if fuel consumption is greatly
affected by driving conditions.
• The display shows estimated values.
Indications may not be the same as
actual values.
• For "L/100km" or "km/L" setting, you can
change the units that instantaneous fuel
consumption is displayed in. Refer to
"Average fuel consumption" in this sec-
tion.
Average fuel consumption
If you selected average fuel consumption
the last time you drove the vehicle, the dis-
play shows the last value of average fuel
consumption from previous driving when
the ignition switch is turned to the "ON"
position or the engine switch is pressed to
change the ignition mode to "ON". Unless
you reset the value of average fuel con-
sumption, the display indicates the value of
average fuel consumption which includes
average fuel consumption during previous
driving.
To reset the average fuel consumption to
zero, push and hold the indicator selector
knob (3) for a while when the display
shows the average fuel consumption.
NOTE:
When you reset the indication or reconnect
the negative (–) terminal to the battery, the
value of average fuel consumption will be
shown after driving for a while.
(For "L/100km" or "km/L" setting)
To change the unit of average fuel con-
sumption, while pushing and holding the
trip meter selector knob (2), turn the indica-
tor selector knob (3).
79MH0-74E