Security System - Suzuki Ciaz Owner's Manual

BEFORE DRIVING
Replacement of the battery
If the transmitter becomes unreliable,
replace the battery.
To replace the battery of the transmitter:
EXAMPLE
(1)
1) Remove the screw (1), and open the
transmitter cover.
2) Remove the transmitter (2).
EXAMPLE
(2)
(3)
(3) Lithium disc type battery:
CR1620 or equivalent
2-13
3) Put the edge of a flat blade screwdriver in
the slot of the transmitter (2) and pry it open.
4) Replace the battery (3) so its + terminal
faces the "+" mark of the transmitter.
5) Close the transmitter and install it into the
transmitter holder.
6) Close the transmitter cover, install and
tighten the screw (1).
7) Make sure the door locks can be operated
with the transmitter.
(2)
8) Dispose of the used battery properly
according to applicable rules or regulations.
Do not dispose of lithium batteries with ordi-
nary household trash.
WARNING
68LM248
Swallowing a lithium battery may
cause serious internal injury. Do not
allow anyone to swallow a lithium
battery. Keep lithium batteries away
from children and pets. If swallowed,
contact a physician immediately.
NOTICE
The transmitter is a sensitive elec-
tronic instrument. To avoid damaging
it, do not expose it to dust or mois-
ture or tamper with internal parts.
NOTE:
Used batteries must be disposed properly
according to applicable rules or regulations and
68LM249
must not be disposed with ordinary house-
hold trash.

Security System

The security system is armed after you
lock all doors by using the keyless entry
system transmitter, keyless push start sys-
tem remote controller or request switch.
Once the system is armed, any attempt to
open a door by using any other means (*)
than the keyless entry system transmitter,
keyless push start system remote control-
ler or open the engine hood, will cause the
alarm to be triggered.
* These means include the following:
– The key
– The lock knob on a door
– The central door locking switch
– The trunk lid unlatch button
– The trunk lid emergency lever
Also, in case that you have set the shock
sensor to enabled state and set sensitivity
of the pre-warning function and full blast
warning function to a level other than 0, the
warning will be triggered in case of any
attempt to tamper with the vehicle. The
shock sensor can be selected enabled or
disabled state, and sensitivity of each
warning can be adjusted as desired. To set
the shock sensor, ask your authorised
Maruti Suzuki workshop or use the setting
mode of the information display.
79MH0-74E