Suzuki Ciaz Owner's Manual page 71

EXAMPLE
NOTE:
• When you change the units that average
fuel consumption is displayed in, the
instantaneous fuel consumption units will
be changed automatically.
• When you reconnect the negative (–)
terminal to the battery, the unit of the
average fuel consumption will be reini-
tialized. Change the unit again to your
preference.
Driving range
If you selected driving range the last time
you drove the vehicle, the display indicates
"---" for a few seconds and then indicates
the current driving range when the ignition
switch is turned to the "ON" position or the
engine switch is pressed to change the
ignition mode to "ON".
The driving range shown in the display is
the approximate distance you can drive
until the fuel gauge indicates "E", based on
current driving conditions.
When the low fuel warning light comes on,
the display "---" will appear.
If the low fuel warning light comes on, fill
the fuel tank immediately regardless of the
value of driving range shown in the display.
When you refuel, the driving range is
updated. However, if you only add a small
amount of fuel the correct value will not be
displayed.
NOTE:
68LM262
• If you refuel when the ignition switch is in
the "ON" position or the ignition mode is
"ON", the driving range may not indicate
the correct value.
• When you reconnect the negative (–)
terminal to the battery, the value of driv-
ing range will be shown after driving for a
while.
Odometer
When the ignition switch is in the "ON"
position or the ignition mode is "ON", the
display (D) shows the odometer.
The odometer records the total distance
the vehicle has been driven.
BEFORE DRIVING
NOTICE
Keep track of your odometer reading
and check the maintenance sched-
ule regularly for required services.
Increased wear or damage to certain
parts can result from failure to per-
form required services at the proper
mileage intervals.
Clock
When the ignition switch is in the "ON"
position or the ignition mode is "ON", the
display (E) shows the time.
To change the time indication:
1) Push the trip meter selector knob (2)
and the indicator selector knob (3)
together.
2) To change the hour indication, turn the
indicator selector knob (3) left or right
repeatedly when the hour indication
blinks. To change the hour indication
quickly, turn and hold the indicator
selector knob (3). To set the hour indi-
cation, push the indicator selector knob
(3) and the minute indication will flash.
3) To change the minute indication, turn
the indicator selector knob (3) left or
right repeatedly when the minute indi-
cation blinks. To change the minute
indication quickly, turn and hold the
indicator selector knob (3). To set the
minute indication, push the indicator
selector knob (3).
79MH0-74E
2-48