Clear Cmos Setup; Onboard Lan1/Lan2 Setting; Onboard Keyboard/Mouse Source Setting; Connection - ICP Electronics ROCKY-772EV Manual

• JP6 : DiskOnChip Memory Address Setting
Address
CE000 – CFFFF
D6000 – D7FFF
DE000 – DFFFF
2.6

Clear CMOS Setup

If want to clear the CMOS Setup (for example forgot the
password you should clear the setup and then set the password
again.), you should close the JBAT1 (1-2) about 3 seconds,
then open it again. Set back to normal operation mode, open
• JBAT1 : Clear CMOS Setup (Reserve Function)
JP1.
JBAT1 DESCRIPTION
1-2 Normal Operation
2-3 Clear CMOS Setup
2.7 Onboard LAN1(JP4) / LAN2(JP2) Setting
The onboard LAN controllers can be disabled if you don't want to use
then. All the hardware resource will be released. After they are disabled.
JP2/JP4 DESCRIPTION
CLOSE Enable
OPEN Disable
2.8

Onboard Keyboard/Mouse source Setting

JKB1 DESCRIPTION
1-2 Vcc (+5V)
2-3 5VSB
1-2 3-4 5-6
OFF ON ON
ON OFF ON
OFF OFF ON
13
3

Connection

This chapter describes how to connect peripherals, switches
and indicators to the ROCKY- 772EV board.
Table of Connectors
LABEL
FAN1,FAN2 CPU /SYSTEM Fan Connectors
CN1 ATX 20-PIN Power Connector
CN2 IrDA connector
CN3 ATX BUTTON (Power ON) Switch
CN5 Parallel Port Connector
CN6 FDC Connector
CN7 Secondary IDE Connector
CN8 Primary IDE Connector
CN9,CN10 USB Connectors
CN11,CN14 Serial Port 10-pin Connectors
CN12 External Switches and Indicators
CN13 Backplane to Mainboard Connectors
CN16,CN17 LAN State LED Connectors
CN18 AUDIO MIC-IN
CN19 AUDIO LINE-IN
CN20 AUDIO CD-IN
CN21 VGA 15-pin Female Connector
CN22,CN24 LAN RJ45 Connectors
CN25 External 5-pin Header Keyboard Connector
CN26 PS/2 MOUSE & KEYBOARD Connector
FUNCTION
14