Table of Contents
Advertisement
■
Recording
Striping or flicker may appear under lighting such as fluorescent lighting and LED lighting
fixture.
• This is characteristic of MOS-type sensors like the one in this camera. This is
not a malfunction.
• If you are taking pictures using the electronic shutter, the striping may be
reduced by setting a slower shutter speed. (→58)
• When noticeable flicker or striping is seen under lighting such as a fluorescent
or LED lighting fixture in video recording mode, you can reduce it by setting
up [Flkr Decrease] (→180) and fixing the shutter speed. It is possible to select
a shutter speed from [1/50], [1/60], [1/100], or [1/120]. You can set the shutter
speed manually in the Creative Video Mode. (→77)
Cannot record pictures. The shutter will not operate immediately when the shutter button is
pressed.
• When [Focus/Release Priority] is set to [FOCUS], the camera will not record until proper focusing is
achieved. (→185)
Recorded pictures look white.
• Lens is dirty (fingerprints, etc.).
→ Turn the camera on to extract the lens barrel, and clean the front lens surface with a soft, dry
cloth.
Recorded pictures are too bright/too dark.
• AE Lock (→99) is set inappropriately.
Some pictures are taken when I press the shutter button just once.
• Drive Mode is set to other than [Single]. (→124)
• Bracket recording is set. (→128)
Correct focusing is not achieved.
• The subject is outside the focusing range.
• [Focus/Release Priority] is set to [RELEASE]. (→185)
• [Shutter AF] is set to [OFF]. (→183)
• AF Lock (→99) is set inappropriately.
• If there are fingerprints or dirt on the front lens surface, the focus may not be set on the subject.
Recorded pictures are blurred. The stabilizer function ineffective.
• The shutter speed is slower in dark locations and the stabilizer function is less effective.
→ Use a tripod and the self-timer (→127) when using a slower shutter speed.
278
Others
Q&A Troubleshooting
Advertisement
Table of Contents
