Briggs & Stratton Legacy XL Operator's Manual page 28

Brake Adjustment
1. Disengage the PTO, stop the engine, block the wheels,
remove the ignition key, and engage the parking brake.
2. Remove the mower deck. See Mower Deck Manual for
removal and installation instructions.
3. Locate the brake spring (A, Figure 29). Measure the
length of the compressed brake spring with the parking
brake on. The compressed brake spring length should
be 3-1/2 to 3-3/4" (8.9-9.5cm).
4. If necessary, adjust the brake spring locknut to achieve
the correct compressed spring length. If this does not
correct a braking problem, see your dealer.
A
Figure 29
Taillight and Dash Light Replacement
1. Twist the socket counterclockwise and pull out to
remove it from the taillight or dashboard display as
shown in Figure 30.
Figure 30
2. Remove and replace old bulb with a new identical bulb.
3. Reinstall socket into taillight bezel or dashboard display.
28
3.5-3.75"
(8.9-9.5cm)
Headlight Replacement
1. Open the hood.
2. Remove the forward heat shield (A, Figure 31).
3. Remove light bulb socket (B) from the bezel (C) by
twisting it clockwise and pulling it out.
A
Figure 31
4. Use a rag or gloves to remove and replace the light bulb
with an identical halogen bulb. DO NOT TOUCH THE
BULB WITH YOUR BARE HANDS.
5. Reinstall the socket into the bezel.
B
C